INSTRUCTIONS FOR USE
Previous preparation for carrying out the test:
- Clear, clean and dry a flat surface.
- Check the contents of the test kit
- Make sure it is not damaged or broken.
- Have a stopwatch on hand.
- Before taking the sample, blow your nose several times.
- Wash your hands
Procedure for performing the test:
- Remove the aluminum foil from the top of the buffer solution tube extraction.
- Insert the tube into the hole in the kit box (or place the tube in the tube holder).
- Open the swab packaging at the end of the toothpick. Caution: Do not touch the absorbent tip of the swab with your hands.
- Insert the entire absorbent tip of the swab into one of the nostrils. With a gentle rotation, push the swab within 2.5 cm of the edge of the nostril.
- Rotate the swab 5 times, rubbing the inside walls of the nostril. Remove the swab and insert it into the other nostril. Repeat the previous step.
- Insert the swab into the tube and shake it for 30 seconds.
- Rotate the swab 5 times while pressing the side of the tube.
- Remove the swab while pressing the tube.
- Tightly screw the dropper cap onto the extraction buffer tube containing the sample. Mix the sample well by swirling or shaking the bottom of the tube.
- Gently squeeze the tube and administer 4 drops of solution into the sample container.
- Read the result when the timer reaches 15-30 minutes. DO NOT read the result after 30 minutes.
- Next, discard the test and all the utensils that we used for the test in the household waste container, following the protocol established by the health authorities.
- It should not be deposited at the SIGRE point of the pharmacy, or on public roads.
Interpretation of the results:
NEGATIVE: If within 15 to 30 minutes a colored line in the control zone (C) but no colored line is observed in the test zone (T), the test is valid and negative. A negative result does not exclude a SARS-CoV-2 viral infection and, in case of suspicion of COVID-19, it must be confirmed by molecular diagnostic methods.
POSITIVE: If two colored lines appear within 15 to 30 minutes, one in the control area (C) and the other in the test area (T) , the test is valid and positive. The result is considered positive no matter how faint the colored line of the test zone (T) is. A positive result does not exclude coinfection with other pathogens.
INVALID:If no colored line appears in the control area (C) within 15 to 30 minutes, the test is invalid. Repeat the test with a new test cassette.